Redring Powerstream RP1 9.5KW Instant Water Heater 45793201

  

One basin and one shower (use mixer kit - extra). Or of course one basin or one shower (with the mixer kit - extra). Much cheaper than a central hot water storage cylinder and far simpler to fit (just feed cold water and attach an appropriately sized electrical supply).

Also, because they only work on demand and do not store any hot water, heat loss is extremely minimal making them economical to run. Output water temperatures of around 54 degrees C are achievable with an incoming cold water feed of 12 Degrees C at rate of 4L per min. If you need higher temperatures or a faster flow rate then take a look at the RP1's bigger brothers (same physical size) in 10.8kw and 12kw. The 9.5kw unit will require either a 6mm or a 10mm twin and earth (6242Y). This depends mainly on how long the run of cable is from the fuseboard to the water heater. Dimensions of the water heater outer casing: L 307mm x W 160mm x D 74mm. Use existing taps or mixers (spray taps work best). Standard supply from mains cold water.

Hardly takes up any space. Can be fitted remotely from the outlets if required. Zero standing water temperature loss. High and low power options inside unit. Fit horizontally or vertically if required (not upside down though).

The RP1 is not warrantied for use with baths or large kitchen sinks. We recommend the Redring RM1 shower mixer kit for all shower applications. This item is in the category "Home, Furniture & DIY\Heating, Cooling & Air\Heaters & Radiators\Water Heaters\Standard Water Heaters". The seller is "fastlec" and is located in this country: GB. This item can be shipped to United Kingdom.

• Tank Capacity: Instantaneous
• Heating System: Instantenous (Tankless)
• Room: Bathroom
• Power Source: Electric
• Application: Whole Room
• Colour: White
• Mounting Location: Under Sink
• Voltage: 240 V
• UPC: 5017084453016
• EAN: 5017084453016
• Brand: Red Ring
• Type: Heaters
• MPN: 45793201
• Features: Wired