It can be used in any location with good ventilation. Q: What diameter of exhaust pipe is needed and how do you connect it? You don't need to connect any exhaust pipe, as the product itself has several emission holes.Q: WHERE and HOW would you connect these pipes? If you wish to install a pipe anyway, use a pipe with an inner diameter of 9 mm and an outer diameter of 10 mm. Q: What kind of decompression valve does it need? It needs one rated 2800 Pa.
Q: Does this product use liquefied petroleum gas or natural gas? It uses liquefied petroleum gas (LPG).
No worry about cold water while you are taking a shower! This hot water heater provides a better washing experience. It also features manifold protection and easy operation.After you unwrap the package, hang it onto the wall and have a try. Please don't install it in your bathroom. With a high gas burning efficiency, the heater can provide you with maximum 8-liter hot water not over 60? Our hot water heater is CE certified and offers manifold protection such as overheat protection automatically shut down over 60?
, low water flow protection (0.025MPa), water over pressure protection (0.8MPa), etc. If the fire is accidentally switched off, the heater will automatically stop. There are altogether 3 knobs for gas control, temperature control and summer/ winter switch. When you switch to the summer mode, the heater will shut off 1/4 fire rows and save 40% energy.This highly efficient heater lowers electricity & gas bills. Attention: Please read cautions below before using the water heater! Make sure there is good ventilation around the water heater. Do not install in confined areas with low ventilation like bathroom! This water heater should only be used with Liquefied Petroleum Gas (LPG). Check the gas connection regularly to make sure no gas leaking risk. Please set the temperature below 60? If the water heater shut down over 60? Please reopen the faucet to turn on the heater. Energy type: liquefied petroleum gas (LPG) only. Maximum outlet water flow: 8 liter per minute. Minimum inlet water pressure: 0.025MPa. Maximum inlet water pressure: 0.8MPa.
Electrical pulse ignition with 2 D type batteries. Exhaust smoke outlet diameter: 9cm. Gas inlet thread: BSPP 1/2 inch male.
Gas inlet pipe adapter hose fitting: BSPP G 1/2 inch female to 1/6 inch. Water inlet thread: BSPP 1/2 inch male. Water outlet thread: BSPP 1/2 inch male. This item is in the category "Home, Furniture & DIY\Heating, Cooling & Air\Heaters & Radiators\Water Heaters\Standard Water Heaters". The seller is "mameishangmao" and is located in this country: GB.This item can be shipped to United Kingdom.