Scope of Application: Suitable for daily washing, washing hands, washing dishes, washing vegetables, washing face, bathing, the temperature range is between 30-55 degrees. Simple and Portable: Small size, lightweight and portable, does not take up space, easy to carry, and can be placed anywhere. Fast Heating: Simple and convenient installation, suitable for installation in kitchens, toilets, showers, public toilets, etc. Instant Hating: Multi speed temperature regulation, intelligent frequency conversion to save power, and function upgrades are only for you to consider more comprehensively. Remote Control Switch: You can control the power on or off, and adjust the temperature through the remote control, which is fast and convenient.
Item Type: Instant Electric Water Heater Wire: 6? Voltage: 220V Power: 8500W Frequency: 50-60Hz Material: Aluminum Casting Weight: Approx. 3607g/127.2oz Remote Control Battery Type: 2 x AAA Batteries (Battery Not Included). 1 x Remote Control(Battery Not Included). 1 x Remote Control Holder.Check whether power supply is powered on normally, the indicator light on power on display will light up to show temperature, and it will not light up if not powered on. Under normal power on conditions, the water current is turned on, press the middle switch key, the machine starts heating, and the water heater displays: set temperature/water current/outlet temperature.
If the temperature does not rise, there are two possibilities: one is that the temperature control switch (overheat protection switch) inside the water heater jumps, press the temperature control switch to restore it. The other is that the heating pipe is faulty, and the heat pipe can be replaced. If there is no heating, the display shows temperature, but water flow and set temperature are not displayed, indicating that the water flow does not pass through water heater, or water pressure is too low, or installation direction is wrong. Note that water inlet and outlet must be installed correctly, but if the water pressure is sufficient, there is water flow and does not heat, then check at water heater inlet, it may be that something is stuck on the, causing water heater to not start. Recommended that length of water pipe at the water heater outlet should not exceed 3 meters.
If it exceeds the length of the water pipe, there may be a water pressure difference, water pressure is not enough to start. (If the water tower is used in rural areas, the height of the water tower is required to be higher than 10 meters, so that the water pressure reaches the start value). Display shows that E1 is over temperature, E4/E5 or temperature sensor is faulty, first power off, run the machine with cold water, and then use it when it is powered on, pay attention to normal use of water flow not too small. Heating tube failure shows E2, and heating tube needs to be replaced.
Instead of leaving negative/neutral feedback or opening a dispute. Our listing price includes the value of goods, packaging cost, and export.
Please check with your country's. We will reply your message within 48 hours.If you do not receive our reply within 48 hours, pls. Post a message again because sometimes our message system may block some emails. If you are satisfied with our service, pls.
Our aim is to provide Level Customer Service, your recognition will encourage us greatly and serve you better. We strive to keep all our customers satisfy. We will do our up most to exceed your expectations in customer service, communication and dispatching of your orders.This item is in the category "Home, Furniture & DIY\Heating, Cooling & Air\Heaters & Radiators\Water Heaters\Standard Water Heaters". The seller is "rightshere" and is located in this country: CN. This item can be shipped worldwide.