In low pressure areas, water pump can be applied to increase pressure. Freestanding Design - Equipped with an independent stand, no worry about finding a place to hang it.
All in One Bag - You can put the appliance in the provided waterproof bag and take it outdoors, like campsites, RVs, stables, remote areas, etc. Easy Control - Simply turning the gas and water control knobs to get your desired temperature.Easy to Install and Operate. Install Two Support Stands (Freestanding Design) Connect the gas water heater to the two stands with the provided screws. Water Inlet and Outlet Connections 1. Attach the shower kit (provided) to the hot water outlet. Attach the water hose (not provided) to the cold water inlet. Adjust the water flow rate via the button on the shower head. 3 sprays for your choice.
Gas Inlet Connection Attach the provided gas regulator to UK standard propane gas cylinder. Check carefully gas leaking by spraying soap solutions on all gas joints. Note: The provided gas regulator is for propane gas bottle with 27mm clip-on connector.You will need another 29 or 30mbar gas regulator for your butane gas bottle. Batteries Insert Insert 2 "D" size batteries (not included) in the battery compartment. Make sure the direct of the batteries is correct. Temperature Control Open gas valve and switch on the shower head, water flows, water heater turns on automatically.
Please just enjoy your hot shower instantly with Camplux AY132Max. Please note: Please drain the residual water out of the appliance when temperature is near or below 0°C.
Product Specifications Max Hot Water Output: 5 litres per minutes Overheat Protection: at 85°C Power Output: 10 kW Gas Type: Propane gas or butane gas Gas Pressure: 37mbar for propane gas or 28-30mbar for butane gas Power Source: 2 D-cell batteries Average Battery Life:? 180 days Applicable Water Pressure: 0.257.5 bar Gas Fitting Nut: 1/2" BSP Water Fitting Nuts: 1/2" BSP Product Size: 290 x 110 x 376 MM Product Weight: 4.54 kg. Included Components: Shower head with 150cm extended hose, gas regulator with 150cm hose, installation kits, instruction manual. Flame failure protection, anti-dry combustion protection, over heating protection, anti-freezing protection. What gas is this appliance suitable for?Propane or butane gas bottles. The supplied gas regulator is for propane gas bottle. You will need another 30mbar gas regulator if you use the appliance on butane gas bottle. What else do I need to install this gas water heater? You will additionally need a LPG bottle, 2-D-size batteries, inlet water hose. If your local water pressure is low (under 1 bar) or the inlet water source is a water tank, you will need another water pump and 12V power source. Where can this product be used? It is recommended to install this product in a well-ventilated place, such as outdoors, garden, balcon, horse stables, ect.. Does this water heater have to be wall-mounted? This product is equipped with a freestanding stand, so it can be used either hanging or standing.
It needs to take the whole set.